Legrand Salamandre distribution trunking

Back to Blog Listing

Salamandre distribution trunking sets the standard for fitting speed. With its unique pre-fitted coupling system, integrated shake-proof screws and a clip-on lid, fitting times can be 50% quicker than any alternative, at least. Together with a smooth safety edge for easier handling, the extensive Salamandre range is the ideal fit for anyone focused on reducing installation times.

The innovative design of Salamandre has led not only to real time, demonstrable savings for installers and contractors, but also to a significantly reduced total installed cost. Save time on site, save money on labour costs.

More innovations... more ways to save time

• Clip-on lid

• Pre-fitted couplers

• Multi-head screws

• Convenient slotted ends

• Safety edge


Salamandre IP4X distribution trunking meets the IP4X requirements of the amendment to the 17th Edition Wiring Regulations which came into force on January 1st 2012. This has been achieved through the introduction of a cover strap, which is simply connected to each coupler over the joint between the two lids, and a new range of IP4X fittings that integrate fully with existing lengths and accessories to deliver a fully compliant solution


Salamandre lighting trunking has been designed with ease and speed of installation in mind:

• Full width covers can be used throughout the installation eliminating the need for additional fitting covers

• Wider opening for increased space and easier access to cables

• Friction grip couplers and fittings are automatically held in place by metal tabs that grip the trunking base leaving hands free to tighten fixing screws

• Fixing screws are supplied in the backed-off position, making it easy to just slide the connector into place and secure the screws

Faster by Design

We continually look for ways to improve our product ranges.  In the case of cable management, every improvement we make has the installer in mind and is based around the three areas that 

make up our ‘Faster by Design’ ethos.

Our products are not only faster to install, they’re also easier to handle and require fewer components - reducing the total installed cost of your project. 

In the UK we manufacture approximately 85% of everything we sell, which means we have local expertise in research and development, design, production and technical support. Swifts cable 

ladder and tray, two of our most recognised names in cable management, have been designed and manufactured in the UK at our Scarborough site since the 1960s. 

To discover more about our Faster by Design cable management ranges, click below to download the Faster by Design brochure or visit the cable management page.

Or contact our technical team for free support on technical@dpbuildingsystems.co.uk or 0121 706 7777, there is also information on Legrand suplplier shop Click Here